Product Information Sheet - 32400N030 ThermaVac® Reusable Vacuum Bag Substrate Uncured Silicone Rubber

(800) 935-2940 solutions@rogerscorp.com

Product Design and Construction
Interleave/Carrier: 0.076 mm Polyethylene Side 1: 0.762 mm Uncured Interleave/Carrier: 0.127 mm Release PET Overall Product Thickness: 0.762 mm Color: Natural/ Translucent	Interleave Side 1 Interleave

Basic Physical Properties	Value	Units	Test Method
Durometer	55	Shore A Points	ASTM D2240
Tensile Strength	8963	kPa	ASTM D412
Elongation	700	%	ASTM D412
Tear Strength	35.0	N/mm	N/A
Specific Gravity	1.20	N/A	Arlon SQA-TMS-024

Construction	Value	Units	Test Method
Construction Designation	Construction 0	N/A	Code Definitions
Color	Natural/ Translucent	N/A	N/A

Extended Physical Properties	Value	Units	Test Method
Total Product Weight	0.915	kg/m2	N/A
Compression Set	28	%	N/A

Heat and Flame	Value	Units	Test Method
Min. Operating Temp.	-57°	°C	N/A
Max. Operating Temp.	232°	°C	N/A

Processing and Packaging	Value	Units	Test Method
Shelf Life	3	Months	N/A
Shelf Life Storage Temp	4.4°	C	N/A
Interleave 1	Polyethylene	N/A	N/A
Interleave 1 Thickness	0.076	mm	N/A
Interleave 2 / Carrier	Release PET	N/A	N/A
Interleave 2 / Carrier Thickness	0.127	mm	N/A
Recommended Cure Cycle	30 minutes @ 350°F	N/A	N/A
Recommended Postcure Cycle	440°F for 4 hours after 30 minute ramp-up cycle	N/A	N/A

Note: Shelf life is defined as the duration of time for which the product will meet the physical characteristics outlined on this page. It does not guarantee the product's usefulness in all applications.

Note: Bond Strength ASTM XXXX test methods:

• For Constructions 0-9, any reported bond strength is "Ply Adhesion"
• For Supported Tapes, reported bond strength is from internal method where tape is hung up, stretched, and rolled up -- the strength required to unroll is reported : ASTM D2148
• For unsupported tape, the reported value is a Government Bond where 2 pieces are bonded together and plied apart: MIL-I-46852C

The data presented in this document represents typical values for the production material. Typical values should not be used for specification limits. Material colors displayed are representations only, actual colors will vary. The information contained in this Data Sheet is intended to assist you in designing with Rogers’ Elastomeric Material Solutions. It is not intended to and does not create any warranties, express or implied, including any warranty of merchantability or fitness for a particular purpose or that the results shown in this Data Sheet will be achieved by a user for a particular purpose. The user should determine the suitability of Rogers’ ARLON products for each application. The Rogers logo, ARLON, and the ARLON logo are trademarks of Rogers Corporation or one of its subsidiaries. © 2020 Rogers Corporation. All rights reserved. www.rogerscorp.com. Modified: 08/09/2022